IND.ACTUATOR SENSOR 2XPNP -5M

Inductive sensor NBN4-F25-E8-5M


• Direct mounting on standard actuators
• Small construction with sturdy plastic housing of protection class IP 67
• LED for power on


Switching function: 2 x normally open (NO)
Output type: PNP
Rated operating distance: 4 mm
Installation: flush mountable
Output polarity: DC
Assured operating distance: 0 ... 3.24 mm
Actual operating distance: 3.6 ... 4.4 mm typ.
Reduction factor rAl: 0.5
Reduction factor rCu: 0.4
Reduction factor r304: 1
Reduction factor rSt37: 1.1
Output type: 3-wire

Operating voltage: 10 ... 30 V DC
Switching frequency: 0 ... 1000 Hz
Hysteresis: typ. 5 %
Reverse polarity protection: reverse polarity protected
Short-circuit protection: pulsing
Voltage drop: ≤ 2.5 V
Operating current: 0 ... 200 mA
Off-state current: 0 ... 0.5 mA typ. 0.1 µA at 25 °C
No-load supply current: ≤ 22.5 mA
Time delay before availability: ≤ 100 ms
Operating voltage indicator : LED, green
Switching state indicator: LED, yellow

MTTFd: 860 a
Mission Time (TM): 20 a
Diagnostic Coverage (DC): 0 %

Standard conformity
Standards: EN IEC 60947-5-2

UL approval: cULus Listed
CCC approval: CCC approval / marking not required for products rated ≤36 V

Ambient temperature: -25 ... 70 °C (-13 ... 158 °F)
Storage temperature: -40 ... 85 °C (-40 ... 185 °F)

Connection type: cable
Housing material: PBT
Sensing face: PC
Degree of protection: IP67

Cable
Wire end ferrules: yes
Cable diameter: 6.8 mm ± 0.2 mm
Bending radius: > 10 x cable diameter
Material: PVC
Colour: grey
Number of cores: 4
Core cross section: 0.75 mm2
Length: 5 m
Mass: 420 g
Tightening torque, fastening screws: M5 x 25 : ≤ 2.7 Nm

Dimensions
Height: 20 mm
Width: 52 mm
Length: 52 mm
Note: Mounted on mechanical drive